RCA E13335, Руководство пользователя

Страница: 23 / 30

19
Connecting Your TV
Using Optional DC Power Cord
Back of TV
How to Operate TV on
DC Power (Car Battery)
Important
•
The DC power cord is designed
for use only in cars with
negative (-) ground (negative
terminal of car battery is
connected to car chassis).
•
The DC power car cord should
never be used in cars with a
positive (+) ground.
•
If you are unable to identify the
negative (-) or positive (+)
polarity of your car, consult your
car’s owner’s manual or check
with a service station before use
.
Replacing Fuse in DC Power
Cord
There is a safety fuse in the plug of
the DC Power Cord. If the fuse
blows out, follow the steps below to
replace it.
1. Unscrew the end of the plug
by turning it counterclockwise.
2. When you remove the end,
you will see the fuse.
3. Replace fuse with a new
125-volt, 13-amp fuse such as
#149823 (available from
your local dealer).
Note: If the spring falls out of the plug,
be sure to install it before you reattach
the end.
4. Screw end (with new fuse
attached) back on plug.
You can power your TV from a 12-
volt car, truck, or RV battery by
using the optional DC power cord.
Instructions are below.
1. Unplug the AC cord from the wall
outlet.
2. Unplug the AC cord from the back
of your TV.
3. Plug the square end of the DC
power cord into the back of your TV.
(Use the same 4-prong outlet for both
the AC power cord and the DC
cord.) The plug is designed to fit
only one way.
4. Plug the round end of the DC
Power Cord into an automobile
cigarette lighter socket.
5. Operate the TV the same way as
you would if the set were on AC
Power.
Cautions for Car Battery
Operation
1. Use of an improper DC power
cord or similar adapter may
result in damage to your TV.
2. Avoid using the TV in a car
unless the engine is turned on and
running. Doing so will drain the
car battery which may cause the
car not to start properly.
3. Do not put the TV on the
dashboard or leave it in a car
parked in direct sunlight since the
temperature inside the car may
damage the set.
4. If taking the TV from a cold car
to a warm room, do not attempt to
plug in the set if there is any sign
of condensation. This could
damage the set.
5. Be sure not to block any of the
ventilation slots when the set is
turned on. This may cause
overheating and damage the set.
HEADPHONE
ANTENNA
POWER CORD