Chapter 1: Connections and Setup
Chapter 1
5
Illustrations contained in this document are for representation only.
TV
The back of your
TV might not look
exactly like the
one shown here.
DS
L D
eco
der
From Cable
or TV Antenna
CABLE/
ANTENNA
TV
VIDEO
R
L / MONO
S-VIDEO
AUDIO
L
IN
OUT
DSL
DECODER
From DSL or other Broadband Connection
EXTERNAL
MODEM
IN FROM
ANTENNA
AC INLET~
OUT TO TV
RF COAXIAL
COMPONENT VIDEO OUT
Y
Pb
Pr
AUDIO
OUT
DIGITAL
AUDIO OUT
OPTICAL
COAXIAL
R
L
R
L
RECORDER
CONTROL
SMART CARD
VIDEO
OUT
S-VIDEO
OUT
NETWORK
ETHERNET
PHONE
LINE IN
HPNA
ETHERNET
DSL LINE
IN
2
4
3
Ext
ern
al M
ode
m
TV + DSL D External Modem
1. Connect the Decoder to the TV
A.
Connect one end of the RF coaxial cable to the OUT TO TV jack on the back of the decoder and
the other end to the TV’s antenna in jack (sometimes labeled CABLE/ANTENNA).
B.
Connect audio/video cables to the AUDIO OUT R and L jacks on the back of the decoder (color
coded, red and white), and to the VIDEO OUT jack (yellow). Connect the other ends of the cables
to the corresponding input jacks on the TV (sometimes labeled VIDEO, AUDIO L/MONO, and
AUDIO R).
Note: If your TV has an S-Video input or component video input, we recommend you make the video connection by using
these jacks instead. Remember to connect audio cables for these connections as S-Video and component video only
carry the picture signal, not the sound.
2. Connect the antenna/cable feed to the Decoder
Connect the cable or antenna RF coaxial cable to the IN FROM ANTENNA jack on your decoder.
Note: To turn off the decoder signal to allow other signals to pass through, press the ANTENNA button on the remote
(may or may not be supported) or press the OFF button on the remote to put the decoder into stand-by mode.
3. Connect the DSL line to the DSL Modem
Connect the DSL line from the wall jack to the DSL LINE IN jack on your modem.
4. Connect the ethernet cable to the DSL Decoder
Connect one end of the ethernet cable to the ETHERNET jack on the modem and the other end to
the ETHERNET jack on the decoder.
5. Plug the power cord into the AC outlet.
Go To Page 10
1B
1A
