RCA 25111, Руководство пользователя

Страница: 19 / 33

Answering a Call
1. Press the HANDSET button to answer the call in handset mode, OR
2. Press the SPEAKER button to answer the call in speakerphone mode, OR
3. Press the HEADSET button or Talk on/off button on headset to answer the call in headset
mode.
4. When finished, press the End soft key.
NOTE: If you have turned the Auto Talk function on, you can pick up the handset from the
base to answer the incoming call directly, without pressing any buttons.
NOTE: Adjust the handset volume by pressing the VOL (- or +) button during a call.
Switching Between the Speakerphone, Handset, and Headset
To switch to the speakerphone, press SPEAKER button on handset.
To switch to the headset, press the HEADSET button or Talk On/Off button on headset to
enable the headset, and the headset indicator turns on.
To switch to the cordless handset receiver, press the HANDSET button to enable the handset
receiver.
NOTE: If a wired headset is plugged into the jack on the base, the wireless headset will be
temporarily disabled.
Mute
To have a private, off-line conversation, use the MUTE feature. The party on the other end
of the line cannot hear you, but you can still hear them.
1. Press MUTE button to activate the mute feature. The mute indicator turns on.
2. Press MUTE button again to turn it off.
Flash
If you subscribe to Call Waiting service from your telephone service provider and you re-
ceive an incoming call on while a call is currently active on the same line, you will hear an
audible tone to indicate another call is waiting.
Also, Caller ID information (if available) for the waiting call will be displayed.
1. To connect to the waiting call, press the FLASH button on your phone. This will place the
original call on hold and connect you to the new incoming call.
2. To switch between the two calls, press the FLASH button.
Inserting a Pause in the Dialing Sequence
Press the #/Pause button twice to insert a delay in dialing sequence when a pause is
needed to wait for a dial tone (for example, after you dial 9 for an outside line, or to wait
for a computer access tone.) Each pause counts as one digit in the dialing sequence, and is
shown as P in the display.
19