5).OR 5 double “beeps” for hard timing
6).The required timing is set by moving the throttle stick to the closed throttle position
7).The new timing is confirmed by a single “beep”(brake on) or a double “beep”(brake off)
z
The timing setting will not change after disconnecting the main power pack.
Notes About Operation:
z
Reversing the motor directions is achieved by the exchanging the position of any two wires connected to motor.
z
These controllers have automatic turn-off with auto detection for the number and type of cells.
z
The speed controller will turn-off the motor when the main power pack voltage falls under “Ni-XX: 5.3V or
reaches 0.7V/cell” or “Li-XX: 6.0V or reaches 3.0V/cell”. It depends on which occurs first.
z
Temperature overload protection is built into the speed controller which turns of the motor when the
temperature reaches 100
℃
.
z
These speed controllers are equipped with protection functions that take care of correct start and operation of
the motor across the whole range of RPM, Current and Voltage.
z
Do not connect the speed controller to just ‘any’ kind of power source. Take care to ensure the right polarity of
Ni-XX or Li-XX power packs only. Your speed controller will be severely damaged if it is connect to a battery
using the wrong polarity.
CE Directives
The products described in this leaflet satisfy the appropriate statutory CE directives:
EMV directives: 89/336/EEC
EMV norms: EN55014-1, EN55014-2
Interference or range problems are most likely caused by unsuitable combinations of RC products and/or
incorrect installations.
Environmental Protection Note
When this product comes to the end of its useful life, you must not dispose of it in the ordinary domestic waste.
The correct method of disposal is to take it to your local collection point for recycling electrical and
electronic equipment. The symbol shown here, which may be found on the product itself, in the
operating instructions or on the packaging, indicates that this is the case.
Individual markings indicate which materials can be recycled and re-used. You can make an
important contribution to the protection of our common environment by re-using the product,
recycling the basic materials or recycling redundant equipment in other ways.
Remove batteries from your device and dispose of them at your local collection point for batteries.
If you don‘t know the location of your nearest disposal centre, please enquire at your local council office.
Changsha KEDA Model, No.597 , DeYa Road, KaiFu District, Changsha City, 410003 Hunan Province
(China) Date : 07/2006
