2.1 During charging, the balancer will automatically check the cells all the way, a by-pass current will occur when it finds any imbalance cell, and
then the relative green LED will flash slowly.
Step 3: Cut-off charging and malfunction handling
3.1 During Charging, when the charger cut-off the charging, please observe the following status, and follow the below guide:
3.1.1 If the green LED still flash slowly, it means there are imbalance cell(s). The balancer will go on balance the cells until all the green LEDs turn off.
Then you can repeat from step 1 to fully charge your battery.
3.1.2 If all of the green LEDs turn off, it means that the battery is balance and fully charge. Please un-plug the battery and the charger, your battery is
ready for use.
3.2 During charging, the balancer will cut-off charging (before the charger takes action) under the following condition:
3.2.1 All the cells are balance and reach to 4.25V or any one of the cell voltage reach to 4.3V (the other cell voltage are over 3.7V). The red LED will
flash slowly for 15sec and then turns off, the balancer will cut-off the balancing and charging function. Your battery is ready for use.
3.2.2 Or, any one of the cell voltage reach to 4.3V and any one of the cell voltage lower than 3.7V.
The red LED and the relative green LED ( which the cell voltage is lower than 3.7V) will flash quickly for 15sec and then turn off, the balancer will
cut-off the balancing and charging function for safety purpose. It means that the relative cell (the green LED indicates) is damage, please
un-plug the battery and charger immediately, discharge the battery and dispose properly.
The following chart shows the connection between the balancer and the battery:
Balance connecting adaptor and available additional spare parts
The pitch (the space between the pins) of the balancing connector of RC SYSTEM battery is 2.5mm. We will supply 2.5mm pitch adaptor as a standard
part of SA10126 balancer. Since there are 2.0mm pitch balancing connector in the market, we can also supply this adaptor for your option to easily charge
these battery with SA10126 balancer. You can contact and purchase from your local RC SYSTEM’s distributors in need.
SA10126 standard adaptor (pitch 2.5mm) available 2.0mm pitch adaptor
For 2S battery
For 3S battery
For 4S battery
For 5S battery
Warning & Precaution
1. Do connect the balancer only with qualified charger specifically designed for Li-Po battery . Do not use a Ni-MH or Ni-Cd charger.
2. Do not connect the balancer to the power supply or the car Lead-Acid battery directly, do not charge the Li-Po battery without qualify charger.
3. Do not short circuit. Never short circuit the input wires of the balancer, they have electric when the battery connects to the balancer!
4. Do not reverse polarity. Make sure the red wire always connects to the positive (
＋
) ,
and the black wire always connects to the negative(
－
).
5. Never use the balancer unattended
6. Un-plug the balancer from the Li-Po battery and charger when not in use or after fully charge.
7. Do not use in a vehicle.
8. Do not use in direct sun light.
9. Do not use when ambient temperature is extremely high.
10. Use and store in a dry environment.
This product is distributed in the UK by:
Amerang Ltd.
Landing Business Park, Commerce Way, Lancing
GB-West Sussex BN15 8TA
website:
www.amerang-group.com