RC Logger 88016RC (RtF), Руководство по эксплуатации

Страница: 36 / 44

36 | Status Indication Table
28. Status indication table
Type Status Trigger Rear LED Front Arm LEDs Rear Arm LEDs Buzzer
Flight Mode Basic (ACC assisted) Channel 5 : (+100) Magenta Dimming – On/Off None
Expert Channel 5 : (0)
Orange
Dimming – On/Off None
GPS (position hold) GPS fixed - No signal (without Homelock) Refer to chapter ”GPS” Dimming – On/Off Dimming – On/Off Double beep, 2s pause (can be disabled via APP)
GPS fixed - Poor signal (with Homelock) Refer to chapter ”GPS” Dimming – On/Off Dimming – On/Off Single long beep at take-off
Channel 5 : (-100), strong GPS signal (with Homelock) Refer to chapter ”GPS” Dimming – On/Off None
Flight agility
(Bank selection switch)
Channel 6 No indication Dimming – On/Off None
R.T.H. Return-to-Home Channel 5 triggered via switch or Transmitter (Tx) off White – Blinks continuously (0.5 Hz) Same as buzzer Same as buzzer Double beep, 1.5 sec pause.
Long beep at every step of the process.
Lost locator SWA (Channel 7) or Hard impact (crash or hard landing) According to flight mode S.O.S S.O.S S.O.S
Flight Error Low battery level 1 Battery <11.4 V White – Blinks continuously (1 Hz) Single flash, 1s pause Single flash, 1s pause Single beep, 2s pause
Low battery level 2 Battery <10.5 V (pilot must land !) White – Blinks continuously (5 Hz) Flashing 2 Hz Flashing 2 Hz Continuous double beeps (1 Hz)
Fail safe (PPM failed) Loss of RF signal White – Blinks continuously (0.5 Hz) Dimming – On/Off Long beep at each stage of process
Flight Check Error GPS / compass failed Start up main board self test
Red – Blinks continuously (1 Hz)
Dimming – On/Off None
Pressure sensor failed
Gyro failed
Power system failed
(ESC/motor)
Permanent system check
System error (pilot must land!)
Red – Blinks (fast)
Flashing 5 Hz Flashing 5 Hz Continuous single beeps (5 Hz)
Calibration Tx Calibration button
Red
Flashing – According to steps Flashing – According to steps None
Gyro Calibration button
Green
Flashing – According to steps Flashing – According to steps None
Compass Calibration button
Magenta
Flashing – According to steps Flashing – According to steps None
Pairing BLE Pairing Pairing button According to flight mode Double flash 1 Hz Solid ON None
Factory state Gyro or compass calibration procedure Invalid gyro or compass calibration
Cyan – Blinks 1Hz (alternating to rear)
Dimming – On/Off None