Building Instructions
Thank you for choosing our product, the Clik Evo. You have just bought a
high performance model for indoor type (F3P) aerobatics.
Please read these Building Instructions carefully. You may prevent
undesirable outcomes...
Team RC Factory recommendation:
You may use several types of glue a contact glue (UHUPor), foam safe CA
–
(for the rest of this document, when we say CA, we mean foam safe or
styro CA), polyurethane glue (Purex), 5 minute Epoxy. We prefer
„
“
UHUpor type glue for depron parts and CA for smaller parts. For good
results and low weight, you may try thinning the contact glue by
technical gasoline or by warming up the glue.
Contact glue how to use: apply a thin layer to both parts and let settle
–
for 3 to 10 minutes (the glue should not be completely dry, only a bit
tacky). After that, hold the parts firmly together. Be careful, because
they cannot be separated again without a big risk of damaging them.
Use paper towel to remove all excess glue. You will have a lighter and
better looking model.
You will be asked to „sharpen the end of a carbon stick“. How to do
it:
Use cca 400 grade sand paper and rub the end of the stick against the
sandpaper, while turning it slowly in your fingers. The angle of the
stick is cca 30 in relation to your workbench.
°
How to split the carbon sticks:
Use your hobby knife blade to roll the stick on your workbench, pushing
down on the blade until the the stick splits.
•
Do not forget to vaccum the carbon dust, if you happen to make any.
You will do your health a big favour!
•
Build your model at standard room temperature (20 22 C).
–
°
•
Ventilate your workshop well, glue fumes are harmful for your
health.
