R A Z O R B A C K O F F R O A D . C O M
13
Failure to follow the safety guidelines listed may result in voiding any applicable warranty, serious bodily injury, or death.
Failure to follow the safety guidelines listed may result in voiding any applicable warranty, serious bodily injury, or death.
It is very important that you properly fill out your product registration form at
razorbackoffroad.com/product-registration/
to register your equipment. By submitting
the information within 15 days of your purchase, your warranty will be validated, ensuring that your equipment will be protected subject to the terms and conditions set
out herein. In the event we need to contact you concerning your registered equipment, Product Updates, Service Bulletins, or Product Recalls, the information you have
provided on the product registration form will ensure your immediate notification. Do your part and let us help you by filling out your product registration form.
It is very important that you properly fill out your product registration form at
razorbackoffroad.com/product-registration/
to register your equipment. By submitting
the information within 15 days of your purchase, your warranty will be validated, ensuring that your equipment will be protected subject to the terms and conditions set
out herein. In the event we need to contact you concerning your registered equipment, Product Updates, Service Bulletins, or Product Recalls, the information you have
provided on the product registration form will ensure your immediate notification. Do your part and let us help you by filling out your product registration form.
Rims that require 10mm Lugs:
Insert the 10mm stud into a Nut Holder.
Insert both the stud and nut holder so that it rests within
the slot facing towards the tire. It is important to note that
you must have the bolt clips only when used together will
the 10mm stud be prevented them from freely rotating
when the stud is nested.
Fig. 2-2
Fig.2-2
STUD INSTALLATION
Fig.2-1
Rims that require 12mm Lugs:
Insert the 12mm stud and rotate it so that it rests within
the slot in the inner facing of the Tire Mount Plate.
Once the stud is in place/slip a single 3/8” O-ring over
the stud’s threads on the opposite side of the Tire Mount
Plate and slide it down until it is touching the Tire Mount
Plate. The 3/8” O-ring will then hold the stud in place
within the slot preventing it from falling out, but still allow
for the stud to be adjusted to fit multiple-Lug patterns,
while mounting the tire to the machine.
Fig. 2-1
