RBH Sound IN-WALL SPEAKERS, Инструкция по установке и эксплуатации, Страница: 3 / 16

Introduction
Break In Period
Congratulations on your purchase of RBH Sound in-wall speakers! Your speakers are the
result of many years of research and development dedicated to producing high quality
products for home audio and audio/video systems.
This manual is designed to give you, the installer or owner, basic information as to the
speaker’s installation and operation. We recommend you thoroughly read through the
material contained in this manual before installing your speakers. This will ensure that
you have an understanding of how to setup your speakers for optimum performance
and allow for years of listening enjoyment.
Allow several hours of listening time to adequately break in the speakers. As the
speakers break-in, the driver suspension will loosen. The result of break-in will be an
increase in low frequency response, improved definition, clarity and detail.
Features
Some RBH Sound in-wall models feature swing out “dog-leg” mounting while
others incorporate a pinch-bracket. Both have pre-started screws for fast and easy
installation. Most RBH Sound in-wall speakers feature swivel tweeters to direct the
sound to the main listening area. All RBH Sound in-wall speakers feature polyswitch
protection circuitry designed to protect the tweeter from being overdriven. This
circuit will automatically reset itself once the volume is turned down or the problem
causing the circuit to activate is removed.
Steep acoustic slope crossovers provide high power handling, minimize driver
interaction anomalies, and also maximizes the clarity with which each driver is
able to produce its respective frequency band.
1
Painting the Speakers
A paint shield is included with your speakers. This shield can be used to protect the
speaker when painting the speaker’s rim (frame) if it has one. If you plan to paint your
speakers, we recommend it be done prior to installation. If you decide to paint your
speakers sometime in the future, it is best to remove the speakers from the ceiling or
wall. When painting speakers, the paint shield must be installed in place of the grille.
The grille can also be painted. Painting the speaker’s grille should be done very careful
with a paint sprayer set to fine. Remove the grille from the speaker, peel off the grille
fabric on the back of the grille and set aside. Place the grilles on a flat surface. Do not
use a brush or roller to paint the grilles as this will clog the holes, greatly reducing the
sound quality of the speakers. Do not paint the grilles while attached to the speakers.
Be sure to remove the paint shields from the speakers and replace the fabric to the
back of the grilles before reinstalling them and using the speakers.