RBH Sound 180, Руководство оператора

Страница: 17 / 28

English –
15
The bearings in idler pulley and retainer pulleys are life
time lubricated. Gear box is filled with oil.
! !
DANGER
Lead acid batteries generate explosive gases. Keep
sparks, flame and smoking materials away from
battery. Always wear eye protection when around
batteries.
BATTERY MAINTENANCE (FIG. 24)
MAINTENANCE
Fig. 24
When starter operates properly and battery connections
are clean and tight, but cranking difficulty is experi-
enced, battery may not be charged. Battery should be
taken to a qualified service station and tested, or charge
the battery with battery charger (See page 7)
If engine will not start right away under normal cranking
speed, continued cranking will run down the battery and
may cause damage to the starter. Check ignition and fuel
systems and correct any faults.
The battery should be kept clean.
If the top has an accumulation of dirt or grease, remove
the battery from lawn tractor for cleaning. The battery
should be cleaned with a mild solution of baking soda
and water. Brush this on, keeping vent plugs tightly in
place to prevent any solution from entering cells.
Allow the solution to work for a few minutes, then rinse
with clean water and wipe battery dry.
If battery terminals are corroded, clean with a wire brush
and coat terminals with petroleum jelly.
! !
DANGER
Be sure to reinstall battery in the same position and
properly reconnect battery cables (red to positive,
black to negative).
Proper care will lengthen battery life. When replacement
becomes necessary, use battery of same size and type for
continued trouble-free service (see Repair parts manual).
! !
DANGER
Always disconnect negative (black) cable first.
Removing positive cable first can result in sparks if
the wrench touches any metal surface. Be sure battery
hold-down bracket does not touch battery terminals
and causes a spark.
!
!
DANGER
Always connect positive (red) cable first. Connecting
negative cable first can result in sparks if the wrench
touches any metal surface. Be sure battery hold-down
bracket does not touch battery terminals and causes a
spark.
SPARK PLUG MAINTENANCE
Spark plug should be checked periodically for excessive
carbon and gap. Use a wire feeler gauge to check spark
plug gap and set 0,7 mm (see Engine operating and
maintenance manual).
AIR FILTER MAINTENANCE
Air filter should be cleaned and/or replaced every 25
hours of operation under normal conditions; more often
under dusty conditions. To clean air filter see Engine
operating and maintenance manual.
HEADLIGHT BULB REPLACEMENT
(FIG. 25 AND 26)
Lift the hood up. The headlight bulbs are secured in the
sleeve with bayonet sockets.
Fig. 25