N
O
I
T
A
D
N
E
M
M
O
C
E
R
/
N
O
I
T
U
L
O
S
M
E
L
B
O
R
P
The hand control ON button is not being fully depressed, or the hose in kinked.
Keep pressing the button until the motor stops automatically, check hose is not kinked.
Release the UP button, which will stop the motor running. The system is designed so that it
cannot over inflate the cushion. Should the blower unit continue to operate for more than 20
seconds after the cushion is fully inflated, release the UP button and consult your dealer for advice.
If the light is out, check the fuse in the main plug. If the light is on wait 40 minutes for unit
to cool down, and try to operate again. If fault continues consult your dealer for advice.
Distorted patches indicate an exposure to temperatures above 50°C.
DO NOT USE
Return for replacement.
The cushion cannot over-inflate unless it has previously been in contact with water above 50°C.
If the remaining seal is 3mm (1/8") wide or less, return the equipment for a replacement cushion.
This will only occur if the inner seam has failed.
Return the equipment for a replacement cushion.
DO NOT USE
Return for replacement cushion.
Air must be forced out of the cushion, disconnect the hose from the blower unit, this will allow most of
the air to flow out of the cushion. To remove the last of the air, apply gentle pressure to the cushion,
or roll the cushion into a cylinder, starting with the end furthest away from the hose.
Ensure the suckers and the bath are free from powdery deposits or oils.
Dry and clean before attaching the cushion.
Contact the manufacturer for spares and screw these in.
DO NOT USE
There is a fault with the cushion or hose. Contact your dealer for advice.
The cushion inflates in a stop and start
fashion.
The cushion is fully inflated but the motor is
not cutting out.
The motor has stopped and will not start
again.
The cushion has distorted in places.
The cushion appears to be over-inflating.
The seams appear to be opening up slowly.
Air bubbles are emitted from between the
double seam at the base of the cushion.
The area around the hose connecting flange
has distorted.
The cushion does not appear to deflate fully.
The cushion is sliding in the bath.
Suckers have come off the cushion.
Air is escaping into the bath water.
8
Trouble Shooting Guide
UK RBF Bath buddy instruction 16pp 21/9/07 09:07 Page 9
