Now pin down the outer wing panel on the X marked spots , Place the help-former as displayed on the
drawing (Note for only speedy flying you can make a 0,5 degree less washout , use the speed washout
setting then, ), make them from 6x12 balsa , important is that they all have the same height, this will
give the correct washout, place then under the trailing edge as per drawing and pin down the wing
bottom on the X markings and the at the helpformer position as on the drawing.
Do make small cuts in the bottom sheeting at the aileron hinge line and edges, this will be very helpful
later
.
Apply the top sheeting with slow ca , take of the wing from the workplate and placeleading edge
