6
KB301
Installation Instructions
*Diagrams are not to scale.
Step 3:
• Mount bed and chassis by screwing two of the mounting
screws into the pilot holes leaving 1/4" (6.4mm) exposed
to allow keyhole slots to be easily mounted over the
screw heads.
Fig. 3
• Place chassis over screws.
Fig. 4
• After securing the unit using the keyhole slots, verify
that the unit is level. Tighten top two screws so that they
are flush with the wall.
• Use the four lower holes as a guide to mark and drill
pilot holes. Use remaining four screws and four washers
to complete installation of bed and mounting bracket.
Insert washers over lower four screws.
Fig. 5
• All
six
screws and four washers must be properly
mounted to the chassis.
Step 4:
• To install liner dispenser ensure liner dispenser is free
from damage. Remove key, unlock, and open liner
dispenser lid. This will expose liner dispenser mounting
holes.
• Line up dispenser mounting holes onto chassis and
secure with the four screws provided.
Fig. 6
Close and
lock the liner dispenser door.
Step 5:
• Clean work area and inspect unit to ensure it opens and
closes smoothly.
Fig. 3
Fig. 4
Fig. 5
Fig. 6
1/4"
(6.4mm)
6
