4
1
Place the handlebars in the
handlebar clamps.
Note:
Handlebar clamps are
located in the plastic bag with
tools and manual.
2
Align with the front fork and
tighten the bolts using a 6 mm
Allen wrench. When properly
tightened, the handlebars should
not move forward or backward.
3
Adjust the brake levers to the
proper place and tighten it with
the 5 mm Allen wrench.
1
Align the two (2) tabs on the plate
with the holes on the front fork and
carefully push inward until plate clicks
securely into place.
Attaching the Handlebars
Tools required: 5 mm and 6 mm Allen wrench
Attaching the Front Plate
ASSEMBLY AND SET-UP
WARNING:
Periodically
check to make sure the handlebar
clamp bolts are tightly fastened.
Inflating the Tires
Tires are inflated when shipped, but they invariably lose some pressure between the point of manufacturing
and your purchase.
WARNING:
Do not over inflate, as this could
damage tire or wheel.
Note:
The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
your electric motor bike tires, first
make sure the pressure gauge is
working, then use very short bursts
to inflate to the correct PSI. If
you inadvertently over-inflate the
tire, release the excess pressure
immediately.
1
Using a bicycle-style tire
pump equipped for a Schrader-
type valve, inflate the tires to
the correct PSI indicated on the
sidewall of the tire.
Need Help?
Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at
www.razor.com
. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
