background image

8

Product does not run

Product suddenly stopped 

working while in use

 

Short run time (less than  

15 minutes per charge)

 

 

Product runs sluggishly

Sometimes the product 

doesn’t run, but other 

times it does

 

Product makes loud noises 

or grinding sounds

Problem 

    Possible Cause 

Solution

Undercharged battery

Loose wires or connectors

Burned out fuse

 

Motor or electrical switch damage

Undercharged battery

Tires are not properly inflated 

Brakes are not adjusted properly 

Riding conditions are too stressful

 

Tires are not properly inflated

Product is overloaded

Brakes are not adjusted properly

Loose wires or connectors

Motor or electrical switch damage

Chain is too dry

Charge the battery. A new battery should be charged for at least 18

hours before using the product for the first time and up to 12 hours after 

each subsequent use.

Check all connections. Make sure the charger port is tightly plugged into the 

charging port on the Pocket Mod, and that the charger is plugged into the 

wall.

Check all wires and connectors to make sure they are tight.

The fuse will burn out and automatically shut off the power if the motor is 

overloaded.

 

An excessive overload, such as too heavy a rider or too steep a hill, could 

cause the motor to overheat. Replace the fuse with a new one of equal 

amperage. Correct the conditions that caused the fuse to burn out and avoid 

repeatedly burning out fuse.

Contact your local Razor authorized service center for diagnosis and repair.

Charge the battery. A new battery should have been charged for at least 

18 hours before using the product for the first time and up to 12 hours after 

each subsequent use.

 

Check all wires and connectors. Make sure the battery connector is tightly 

plugged into the charger connector and that the charger is plugged into  

the wall.

The tires are inflated when shipped but invariably will lose some pressure 

between the point of manufacturing and your purchase. Refer to instruction 

on page 4.

Refer to adjusting the brakes instructions on page 5. 

Use only on solid, flat, clean and dry surfaces such as pavement or level 

ground.

The tires are inflated when shipped but they invariably will lose some

pressure between the point of manufacturing and your purchase.  

Refer to instructions on page 4.

Make sure you do not overload the product by allowing more than one rider  

at one time, exceeding the 170 lb. maximum weight limit, going up a hill or 

towing objects behind the product. 

 

Refer to adjusting the brakes instructions on page 5.

Check all wires around the motor and all connectors to make sure they are 

tight.

Contact your local Razor authorized service center for diagnosis and repair.

Apply a lubricant such as 3 in 1

TM

 or Tri-Flow

TM

 to the chain.

 TROUBLESHOOTING GUIDE

Содержание pocket mad Bistro 15130638













Отзывы: