Razor E300 HD, Руководство пользователя

Страница: 10 / 16

REPAIR AND MAINTENANCE
8
1
Using two (2) 16 mm wrenches, loosen the axle bolts by turning the wrenches counter clockwise. Remove wheel
and install replacement wheel. Note the sequence of the hardware.
Front Tire Replacement
Tools Required: Two (2) 16 mm Wrenches (not included)
Rear Wheel/Hub Motor/Battery Replacement
Tools Required: Phillips Screwdriver, 4 mm Allen Wrench, Two (2) 19 mm Wrenches, Two (2) 10 mm Wrenches,
Two (2) 8 mm Wrenches (not included)
Right Side (Throttle)
1-5 Spacer
1-4 Washer
Fork
1-3 Washer
1-2 Spring Washer
1-1 16 mm Locknut
Middle
1-6 Front Axle Bolt
Left Side (Brake)
1-5 Spacer
1-4 Washer
Fork
1-3 Washer
1-2 Spring Washer
1-1 16 mm Locknut
Note: Front wheel
hardware sequence.
1-1 1-2
1-31-4 1-5
1-6
1-2
1-3
1-4
1-5
1-1
1
Using a Phillips screwdriver and 4 mm Allen wrench
remove the six (6) screws and two (2) Allen bolts and
remove the deck plate. A: Small screw size, B: Allen
bolt, C: Large screw size
3
Disconnect the battery wire connector from the
control module and carefully remove the battery.
Note: If only replacing the battery, install new battery
and reverse steps 1-3.
2
Using a Phillips screwdriver remove the battery strap.
4
Disconnect the motor wire connector from the control
module and remove the wire from guider.
A
A
B
B
A
A
C
C
Note: Color match wires.
5 Pin Connector - 5 Pin Connector
Blue - Blue
Yellow - Yellow
Green - Green
5
With a 10 mm wrench, loosen the brake cable anchor
bolt and disconnect the cable.
6
With two (2) 8 mm wrenches, remove the cable guide
bracket from the frame and brake plate. Keep the bolt,
washer, spacer, and nuts together.