ASSEMBLY AND SET-UP
q
Attaching the Seat (E200S Only)
Tools required:
Two (2) 4 mm Allen wrenches and Phillips screwdriver.
2
Remove the four screws on
the middle of the deck with the
4 mm Allen wrench and the
Phillips screwdriver.
3
Place the seat post on the
deck and secure using the same
4 screws.
1
Attach the seat to the seat
post with two (2) 4mm Allen
wrenches.
Note:
Do not completely tighten at this time. Adjust the seat tilt approximately level to the ground, or
slightly tilted depending on your personal preference. Tighten securely. The seat tilt adjustment should
not move when riding.
USAGE
q
Starting the Scooter
To start unit, turn on power switch and twist throttle with both hands on handlebar.
E200
A
q
Stopping the Scooter
To stop unit, release the throttle and apply the brake until the unit comes to a complete stop.
E300
Note:
As an additional safety
feature, the scooter is designed
to cut power to the motor when
the hand brake is applied.
