HEADLINE
6
CHARGING THE BATTERY
PRE-RIDE CHECKLIST
6
• Initial charge time: 12 hours
• Recharge time: up to 12 hours, even if the light turns
green. Recommended maximum charging time is
24 hours.
• Always charge the battery immediately after riding.
• Fully charge battery before storing for extended
periods of time.
• Unplug charger from the wall outlet when not in use.
• Failure to recharge battery periodically may result in a
battery that will not accept a charge.
• Make sure the electric product’s power switch is
turned
OFF
when unit is not in use. If the power
switch is left on for an extended period of time, the
battery may reach a stage at which it will no longer
hold a charge.
• To ensure long battery life, never store the product in
freezing or below freezing temperatures! Freezing will
permanently damage the battery.
• Run time: Up to 30 minutes of continuous ride time.
Run time may vary depending on riding conditions,
climate and/or proper maintenance.
• Constant stopping and starting may shorten ride time.
• Battery life can vary depending on proper
maintenance and usage of the unit.
Your electric product may not have a fully charged battery; therefore you must charge the battery prior to use.
1
Plug the charger plug into a wall
outlet. The light on the charger
should be green.
Note:
If green light (LED) does not
turn on, try a different outlet.
2
Make sure the power switch is
in the
OFF
position. Plug the charger
into the charger port on the product.
The light on the charger should
turn red during charging. The light
will turn green when the charging
is complete.
Note:
Make sure power is turned
OFF
when unit is not in use. If
the power switch is left on for an
extended period of time, the battery
may reach a stage at which it will no
longer hold a charge.
WARNING:
Use ONLY with the recommended
charger. Batteries are only to be
charged under adult supervision.
The charger is not a toy. Always
disconnect the charger before wiping
down and/or cleaning the electric
product with a damp cloth.
The charger supplied with the
electric product should be regularly
examined for damage to the cord,
plug, enclosure and other parts.
In the event of such damage, the
electric product must not be charged
until it has been repaired or replaced.
Chargers have built-in overcharge
protection to prevent battery from
being overcharged.
Note:
If the charger gets warm
during regular use, this is a normal
response and is no cause for concern.
If your charger does not get warm
during use, it does not mean that it is
not working properly.
Wall outlet - Green (stand by)
Wall outlet and Unit - Red (Charging)
Charging complete - Green (Charged)
Note:
Continue charging unit even if
light turns green prior to 12 hours.
WARNING:
Failure to
recharge the battery at least once a
month may result in a battery that
will no longer accept a charge.
LED
Charger
Brake
Check the brake for proper function. When you squeeze the
brake lever, the brake should provide positive braking action.
When you apply the brake with the speed control on, the
brake cut-off switch will stop the motor.
Tires
Periodically inspect the tires for excess wear and replace
as needed. Regularly check the tire pressure and inflate as
needed. If you get a flat tire, the inner tube can be patched or
a new tube can be purchased from Razor or an authorized
repair center.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken
frames are rare, it is possible for an aggressive rider to run
into a curb or object and wreck, bend or break the frame. Get
in the habit of inspecting your product on a regular basis.
Hardware/Loose Parts
Before every ride, check all parts, such as nuts, bolts, cables,
fasteners, etc., to ensure they are secure and assembled
correctly. There should not be any unusual rattles or sounds
from loose parts or broken components. If the unit is
damaged, do not ride.
Reference “Safety Warnings” on
pages 1 and 2 of this manual.
Safety Gear
Always wear proper protective gear, such as an approved
safety helmet. Elbow pads, kneepads, pants and long sleeves
are recommended. Always wear closed toe shoes (lace-up with
rubber soles) and keep shoelaces tied and out of the way of the
wheels, motor and drive system. NEVER RIDE BAREFOOTED OR
IN SANDALS.
Laws and Regulations
Always check and obey any local laws or regulations.
Insurance
Do not assume that your existing insurance policies necessarily
provide coverage for electric product use. Check with your
insurance company for information regarding insurance.
Storage
Prolonged exposure to UV rays, rain and the elements may
damage the enclosure materials, store indoors when not in use.