Disconnect the connector between the battery
and the control module (Figure 8)
Step 8:
Figure 8
Need Help?
Visit our website for additional instructions at
www.razor.com
or call toll-free at
866-467-2967
Monday - Friday
8:00am - 5:00pm Pacific Time.
3
Step 9:
Using a 4mm hexagonal allen wrench, remove
the 2 bolts (1 on each side) on the battery strap.
(Figure 9)
Use both hands to carefully lift out the batteries. (Figure 10)
Step 10:
Figure 9
Figure 10
Step 11:
1. Place the new battery inside the battery tray.
2. Re-fasten the battery strap around the battery.
3. Re-connect the battery to the control module.
*
Note:
Check that all connectors are securely attached, especially to the power switch as it is possible
connector(s) may get detached when lifting up the plastic body.
4. Re-attach the battery cover.
5. Lower the plastic body back down over the main frame and re-fasten the 2 bolts to the to the rear fender.
6. Re-fasten the 4 bolts on both of the footrest platforms.
7. Re-attach the handlebars.
8. Lift Dirt Quad up and re-fasten the bolts to the battery cover and support bracket.
9. Carefully lower Dirt Quad back down; installation complete.
Attention: Charge battery for 18 hours before initial use.
