RQD031ENr02 Rev. Date: 2021-12-16
3
USERS MUST NOT
position the Raz-ART on a side slope as this could
cause it to tip.
Ramps and Other Inclines
Ramps or other surfaces that are not level (such as slopes into wheel-in
showers) must be tested with an attendant to ensure the stability of the
chair is not compromised. A qualified healthcare professional should be
consulted to assist with this process.
DO NOT push or pull the Raz-ART up or down an incline or ramp that
exceeds a 1:12 grade (5° slope).
DO NOT
allow any user to be propelled (pushed or pulled) in the Raz-ART
in any other manner than by an attendant.
Immersion
The Raz-ART is not designed to be used as a pool chair. Do not immerse the shower
chair in whole or in part, in water or any other liquid. Damage to the shower chair components may result.
Chlorine Exposure
Suitable for use in wet areas, but not pools and similarly corrosive environments.
DO NOT
store the device near pools because chlorine in the air will cause the device to rust.
Transfers
The most dangerous part of using any shower chair is the transfer. Since every chair has different stability
characteristics, it is essential to carefully review and test the transfer technique to ensure that the procedure is
safe. Test transfers should be performed with an attendant who can prevent the chair from tipping or moving
during the transfer. If you feel that the transfers cannot be repeatedly performed safely, contact a healthcare
professional who is familiar with transfer techniques and assistive equipment. Individuals who have not learned
safe transfer skills must seeks assistance during transfers and may require the use of a mechanical lift.
Transferring onto the Raz-ART Shower Chair
ALWAYS
lock all four casters in their outward position (front casters
positioned in the forward position/rear casters positioned to the rear) for
maximum chair stability.
Transfers should never be attempted with the shower chair
positioned on slippery surfaces.
It is recommended that transfers be
performed on clean, dry, non-slippery surfaces. Hard surface flooring
such as tile, wood or concrete may not provide sufficient grip to keep
locked casters from sliding. A fully-carpeted surface is optimal. Be aware
that area rugs and shower mats can slide on floors and thereby present
a hazardous surface.
DO NOT stand on any part of the frame of the Raz-ART.
NEVER use the foot supports(footrests) to assist in transfers.
This
could cause the chair to tip. The footrests should be swung to the side
or removed entirely during transfers to provide unobstructed access to
the Raz-ART.
The Raz-ART
is NOT
intended for use as a transportation device or a
as a long-term seating system.
