BT240
Product Manual
V1.0 RayTools AG. Copy Right
11 | 15
www.raytools.net
•
Install the cover slide (with no front and back) by placing it into
the Cover Slide Drawer.
•
Retain the seal ring into the drawer. Replace with a new seal
ring if it appears to be damaged.
•
Reinstall the cover drawer into the head by depressing the
buttons on either side of the unit.
•
Tighten the locking screw.
Caution
：
Don’t take out the seal ring by digging its edge.
This may damage the seal ring.
4.2.2
Changing 3D Laser Head Cover Slide
•
Open the outside cover of the jet tip
•
Remove the cover slide by depressing the buttons on either
sides of the Cover Slide Drawer
•
Remove the cover side from the drawer by applying
pressure with your fingers to the surface of the cover
slide, opposite the seal ring. The seal ring and cover
slide will pop out. (save the seal ring)
•
Clean or change the cover slide
•
Install the cover slide by placing it into the Cover
Slide Drawer.
•
Retain the seal ring into the drawer. Replace with a
new seal ring if it appears to be damaged.
•
Reinstall the cover drawer into the head by
depressing the buttons on either side of the unit.
•
Rotate and close the jet tip
4.2.3
Changing Collimating Lens Assembly
Changing the collimating lens assembly can be performed while the head is mounted to the machine. This
menu only covers the servicing of a Raytools’ collimator. Refer to third-party collimator’s instructions for its
servicing.
Caution
：
Remove fiber with great care. Damaging fiber end may result in fiber replacement.
Store fiber in such a manner to protect the end of the fiber from being damaged.
•
Wipe away loose debris from BT240
•
Using a 3 mm hex wrench, remove screws holding the
fiber collimating assembly as shown in Figure 11. Take assembly
to a clean area.
•
Loosen the collimator holder and take out the seal ring and the
collimator.
•
Change or clean the collimator
•
Install the collimator in order. Tighten the seal ring and thread
them onto Module FRA.
•
Reinstall components in reverse order.
•
Check the tip centering, laser focus and image focus and adjust
as needed.
Figure 9 Changing
Cover Slide
Figure 10 Inside Structure Of The
Cover Drawer
Figure 11 Collimating
Module CM
