9 | 29
www.raytools.net
BM114S SERIES 6KW Laser Cutting Head User Manual
WARNING:
The optical devices must be kept clean and all dust must be removed before
use. If the laser head is vertically inserted in the optical fiber, the laser head must be
rotated 90 degrees to the horizontal level and then inserted into the optical fiber to
prevent dust from entering the interface and falling on the surface of the lens. Upper limit
in the fiber before fixing the laser head.
2.5
Fiber Insertion and Interface Direction Adjustment
In this paper, an optical fiber insertion method is described in conjunction with a QBH joint.
First, align the red point at the end of the QBH interface with the red point of the handwheel;
then remove QBH dust proof cover and the red mark of fiber output end is aligned QBH red
mark and insert straight to bottom; Then turn the QBH handwheel clockwise. It is in place when
you hear the "Da" voice, then pull the handwheel up and turn clockwise again. (see Figure 3.4)
When the fiber connector is inserted into the interface, if the red dot on fiber is too far
away from the red dot on laser head interface, causing an out of alignment insertion, you can
refer to steps below to adjust the position of fiber interface on laser head for solving the problem.
As shown in Fig. 3.4, unscrew the 4 locking screws of the position of the part icon with a wrench,
rotate the QBH interface and screw the locking screws after the red mark is in place.
