Raytheon HSB L760, Руководство пользователя

Страница: 57 / 224

Chapter 2: Installation 2-27
Ch
ec
k f
or
L
eaks
Figure 2-20: Preparing a Cored Fiberglass Hull
6. Sand and clean the area around the hole, inside and outside, to ensure that
the sealant will adhere properly to the hull. If there is any petroleum residue
inside the hull, remove it with either mild household detergent or a weak
solvent (alcohol) before sanding.
7. Proceed with Seating on page 2-21 and Attaching the transducer on
page 2-23.
Check for Leaks
WARNING:
Never install a thru-hull transducer and leave the boat unchecked for
several days.
1. When the boat is placed in the water, immediately check around the thru-
hull transducer for leaks. Note that very small leaks may not be readily
observed. Do not to leave the boat in the water for more than 3 hours before
checking it again. If there is a small leak, there may be considerable bilge
water accumulation after 24 hours (probably not enough to cause water
damage). If a leak is observed, repeat Seating on page 2-21 and Attaching
the transducer on page 2-23 immediately.
Hull
Dimension equal to the thickness of the hull's
outer skin to ensure adequate clearance
Inner skin
Outer skin
Core
Solid or
hollow
cylinder
D4865_1