RayTek Raynger ST80 ProPlus Enhanced, Руководство пользователя

Страница: 11 / 95

MODE button Functions
Your infrared thermometer measures Maximum
(MAX), Minimum (MIN), Differential (DIF)*, and
Average (AVG)** temperatures each time you take a
reading. This data is stored and can be recalled with
the MODE button (3) until a new measurement is
taken. (See “Hold and Recall” for information on
how to recall stored data.). When the trigger is
pulled again, the unit will begin measuring in the
last mode selected.
Pressing the MODE button also allows you to
access the High Alarm (HAL), Low Alarm (LAL),
Emissivity (EMS), Probe temperature (PRB – only
available when the probe is connected), and Data
logger (LOG). Each time you press MODE, you
advance through the mode cycle. The diagram
shows the sequence of functions in the Mode cycle.
Note : PRB (probe) is only available in the MODE
loop when the contact probe is connected to the
unit.
Selecting a Function
To Select the MAX, MIN, DIF, or AVG mode, pull the
trigger. While holding the trigger, press the MODE
button (3) until the appropriate code appears in the
lower left corner of the display (E). Each time you
press MODE, you advance through the MODE cycle.
The MODE cycle is shown above.
SET
MODE
LOG
3
E
English
9
*DIF shows the difference between the maximum
and minimum temperatures measured
**AVG shows the average temperature reading for
each time the trigger is pulled or the unit is locked
on
1.888.610.7664 sales@GlobalTestSupply.com