RayTek LineScanner MP150, Руководство по протоколу

Страница: 25 / 42

Dedicated Commands
MP150 Protocol
Rev. B4 Aug 2019
25
5.3.3 Examples
Set Sector 2 to be temperature actuated: Send command
ZM23
with a zone duration time of 2.4 s: Send command
ZW20024
starting after a delay of 1.7 s: Send command
ZD20017
after exceeding the setpoint: Send command
TF21
temperature of 123°C: Send command
ZT20123
Setup a 100 line snapshot (in host mode):
Send command
LC100
and initiate it to work by time: Send command
ZM01
cycling every 70 seconds: Send command
ZZ00700
starting after 1.6 s delay: Send command
ZD00016
Setup a 256 points per line (in host mode): Send command
PM3
by 100 lines snapshot: Send command
LC100
initiate it by temperature: Send command
ZM03
increase: Send command
TF01
over 30°C: Send command
ZT00030
Don’t use averaging: Send command
AV0
use a scale max of 180°C: Send command
ST00180
and a scale min of 23°C: Send command
SB00023
5.4 Sector and Zone
It is distinguished between sectors and zones. There are:
•
Sectors if the line count is set to 1 (LC001).
•
Zones if the line count is set greater as 1.
Internally a sector is a zone of length 1.
So a sector can be given by the
SL
and
SR
commands (known from the MP50) or by the more generic
ZP
command with y
n
= 1 :
ZP n c x
1
1 x
2
1 x
3
1 x
4
1
The following commands are used for sectors and zones even though they have the “sector” in its name:
SB “sector bottom” temperature maximum of sector/zone with build in current output
IO_SB “sector bottom” temperature maximum of sector/zone with external module for current
output
ST “sector top” temperature maximum of sector/zone with build in current output
IO_ST “sector top” temperature maximum of sector/zone with external module for current
output
SZ “sector zero” reference current for sector bottom of sector/zone with build in current
output
(not available with external module for current output)
SM “sector max” reference current for sector top of sector/zone with build in current output
(not available with external module for current output)