Raytech WR100-12R, Инструкция по эксплуатации

Страница: 118 / 139

C Service Mode
The Service Mode has limited access. There are several codes accessible for setting parameters.
From the main screen press 'Setup'. Then in the
General screen press 'Service Mode'. Enter the
corresponding code or Exit by pressing '#'.
C.1 Calibrate Touchscreen
The touch screen parameters can be calibrated by the enduser. Enter code 0000# and follow the
on screen instructions as depicted below.
You will see the following screen:
Press and hold stylus on the center of the target
until the cross moves.
Repeat as the target moves around the screen.
If a keyboard is connected, press Enter to
accept the new parameters or Esc to escape.
If a keyboard is not connected, press anywhere
on the screen to accept the new parameters.
Instruction Manual Winding Resistance Meter
Type WR100 / WR50 / WR14
Page 118 of 139