11
www.rayteccctv.com
Raytec Global Tel : +44(0) 1670 520055
Americas Tel : +1 613 270 9990
If an illegal character is used when entering a pin, it will be ignored and
the PIN character count will not reduce. The process to enter a PIN will
have to be repeated.
To delete a PIN you first need to be in Programming Mode. Press STATUS
BUTTON for 4 seconds to go into PIN set mode. LHS LED will flash RED /
GREEN. RHS LED FLASHING RED. Instead of entering one of the known
legal characters press the RESET BUTTON four times. The illuminator will
return to program mode. Note – if you delete the PIN and the illuminator
goes into operating mode, you will not be able to go back to program
mode without recycling the power.
*Note - If you forget your pin and need to make adjustments to the
illuminator you need to do full Re-set. This requires power recycling whilst
pressing the two manual control buttons at the same time. This will restore
factory default settings AND remove the previously programmed PIN.
Both LEDs will flash AMBER to signify that the process has been
completed.
*Note – If you do not want to set a PIN, but want to prevent another
person with a remote setting a PIN, then you need to Disable both the
Remote and the Manual Buttons (See Manual Control Buttons section –
Page 12) The only way another user can then access the illuminator is by
performing a full re-set (see Page 18)
*Note – If you are trying to access a PIN in Operating Mode, hold the
status button down for 4 seconds and both LEDs flash RED, this means
there is no PIN present.
