Catalog No. 6200.183
Replaces: NEW
Effective. 06/2013
POWER
S AVE R
CLEAN
OVERRIDE
HIGH
OVERRIDE
LOW
BACK
POWER
FAULT
+
-
SET
1
2
3
4
5
6
Controls &
LEDs
Description
1
Display Screen
2
LED Lights
Power: Light (Green)
Fault: Light (Red)
3
BACK: returns to previous
program setting and does NOT
accept current screen values
4
Navigation Selector
+ or – increases/decreases
selected value
← or → Navigates to adjust-
able value (digit)
SET accepts the current
screen values
5
Interface Selector
6
Override Buttons
NOTE:
The selector knob must be
turned to RUN for the pump to oper-
ate. When the user presses ← or →
button the cursor moves to the next
or previous position. If the cursor is
at the end of a line when the user
presses the arrow, the cursor moves
to the next line.
PS270VSP
Quick Start Guide
User Interface & Navigation Overview
WARNING:
This product must be installed and serviced by a qualified pool professional,
and must conform to all national, state, and local codes. Before installing this product,
read and follow all warning notices and instructions of this product. Failure to follow
warning notices and instructions may result in property damage, personal injury, or
death.
Only the clock setting is required to enable the PS270VSP to operate at three different
speeds and durations using the pre-set schedule. The preset speeds and schedule
times are detailed in the manual on page 14.
Observe all safety warnings and cautions
Verify the user interface is plugged in
Make certain the motor is properly wired
Turn selector knob to SET CLOCK
Set the Time and Date using the +, -, ←, → buttons
Turn the Selector knob to RUN
NOTE: Must wait until “PRIME MODE” is complete to make changes to OVERRIDE
settings.
Pre-set Schedule
