Raypak B-195, Инструкции по эксплуатации и монтажу

Страница: 13 / 23

SECTION 3. LIGHTING THE HEATER
Safety lighting and other performance criteria were
met for the burner assembly and control assembly
when the heater was tested for design certification
under the ANSI Z21.10.3 Standard
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This heater DOES NOT have a pilot. It is equipped
with a hot surface ignition device which automati-
cally lights the burner.
DO NOT attempt to light the
burner by hand.
B. Before operating smell all around the heater area
for gas. Be sure to smell next to the floor because
some gases are heavier than air and will settle on
the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to push in, move or turn the gas
control knob or lever. Never use tools. If the knob
or lever will not push in, move or turn by hand, don't
try to repair it, call a qualified service technician.
Force or attempted repair may result in a fire or
explosion.
D. Do not use this heater if any part has been under
water. Immediately call a qualified service techni-
cian to inspect the heater and to replace any part of
the control system and gas control which has been
underwater.
HOT SURFACE IGNITION MODELS WITH
ROBERTSHAW GAS VALVE
1. STOP! Read the safety information.
2. Turn off all electrical power to the appliance.
3. Remove front door and control box cover.
4. This appliance is equipped with an ignition
device which automatically lights the burners. Do
not try to light the burners by hand.
5. Push in and move gas control lever counter
clockwise to "OFF" position.
6. Wait five (5) minutes to clear out any gas. If you
then smell gas. STOP! Follow "B" in the safety
information above on this label. If you don't smell
gas, go to next step.
7. Move gas control lever clockwise to "ON"
position.
GAS CONTROL
LEVER SHOWN
IN "OFF"
POSITION
GAS INLET
Fig. # 8934.1
8. Replace control box cover and front door.
9. Turn on all electric power to the appliance.
10. If the appliance will not operate. Follow the
instructions "To Turn Off Gas To Heater" and call
your service technician or gas supplier.
TO TURN OFF GAS TO HEATER
1. Turn off all the electric power to the heater if service
is to be performed.
2. Remove front door and control box cover.
3. Push in and move gas control lever counter
clockwise to "OFF".
CAUTION: Should overheating occur or the gas sup-
ply fails to shut off, DO NOT turn off or disconnect the
electrical supply to the pump. Instead, shut off the gas
supply at a location external to the appliance. Failure
to observe this precaution may aggravate the over-
heated condition resulting in possible damage to the
heater and injury to the user.
13