31
Operation
Remote Control
Your remote control has been programmed at the factory to operate with your garage door opener.
Older Raynor remote controls are NOT compatible, see page 37 for compatible accessories. Programming can
be done through the door control or the learn button the garage door opener. To program additional
accessories refer to the instructions provided with the accessory or visit www.raynor.com. If your vehicle is
equipped with a Homelink
®
, you may require an external adapter depending on the make, model, and year of
your vehicle. Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
USING THE DOOR CONTROL
1.
Press the LEARN button on the door control twice. The Command LED will blink.
2.
Remote Control:
Press the button on the remote control that you wish to operate your garage door.
Keyless Entry:
Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry keypad. Then press
the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) and the Command LED will stop blinking
when the code has been programmed. Repeat the steps above for programming additional remote controls or
keyless entry devices. If programming is unsuccessful, program the remote using the learn button.
LEARN button
Command LED
1
OR
PIN
?
?
?
?
4
GHI
5
JKL
7
PRS
8
TUV
9
WXY
0
QZ
*
#
ENTER
0
QZ
*
#
ENTER
6
MNO
2
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL USING THE LEARN
BUTTON
1.
Press and release the LEARN Button on the garage door opener.
2.
Press and hold the button on the remote control that you wish to use. Release the button when the garage
door opener lights blink or two clicks are heard.
LEARN LED
LEARN
Button
“click”
“click”
1
2
