©2006 The Chamberlain Group, Inc.
114A2201C
All Rights Reserved
PROGRAMMING THE REMOTE TO THE
RECEIVER
With Safety Signal™, the code between the remote control and
the receiver changes with each use, accessing over 100 billion
new codes.
You can activate your opener with up to 8 Safety Signal™
remote controls and one Safety Signal™ Keyless Entry.
1. Pry open the front panel of receiver case with a coin or a
screwdriver
(Figure 4)
. Re-connect power to opener.
2. Press and release the “SMART” button on the receiver. The
“SMART” indicator light will glow steadily for 30 seconds
(Figure 5)
.
3. Within 30 seconds, press and hold the button on the
hand-held remote that you wish to operate your garage door
(Figure 6)
.
The opener will now operate when the push button on either the
receiver or the remote control is pressed.
Repeat Steps 2 and 3 for each remote control that will be used
to operate the garage door opener.
TO ERASE ALL REMOTE CONTROL CODES
Press and hold the “SMART” button on the receiver panel until
the indicator light turns off (about 6 seconds). All remote control
codes are now erased. Then follow the steps above to reprogram
each remote control.
REPLACING THE REMOTE
CONTROL BATTERY
The lithium battery should produce power
for up to 5 years. To replace battery, pry
open case with visor clip or screwdriver,
as shown. Insert battery positive side up.
Dispose of old battery properly.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
WARNING
CAUTION
WARNING
WARNING
3
2
1
Indicator
Light
“SMART”
B
u
tton
SPECIFICATIONS
Output Rating......................................5 Amps 28VAC or DC Max.
Power ....................................................18V - 30V ~, 30mA, 60Hz
18 - 30V
, 30mA
RF Frequency....................................................................390MHz
If the power is other than shown in specifications, Accessory
Transformer Model 85 or 95 is required.
Accessory Remote Controls — Series 900.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or remote control are prohibited, except for changing the code setting or
replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Figure 5
Figure 6
Figure 4
