6
ST70 Pilot Controller Reference Guide
2.2 Dockside and open water procedures
WARNING: Dockside and open water procedures.
The ST70 Pilot must be prepared for use in accordance with the
Commissioning Procedures before it is used for operational purposes.
Failure to comply with this could result in death, personal injury, damage to
your boat and/or poor product performance.
The following procedures are described in the
ST70 Autopilot Controller/SmartPilot X
Commissioning Instructions
and should be performed in the prescribed order when
there is any change in vessel configuration:
•
Vessel type
•
Drive type
•
Rudder check
•
Motor check
•
Compass calibration
•
Auto learn.
2.3 General setup procedures
The setup procedures available depend on the vessel profile as set up during
commissioning (Fishing, Sail or Power), and whether the ST70 Pilot is in Standby or
Auto mode.
Procedure
Sail
Fishing Power
Pilot view (see
Pilot view
on
page 22
)
x
x
x
Display settings (see
Display settings
on
page 7
)
x
x
x
Autopilot calibration (refer to the
ST70 Autopilot Controller/
SmartPilot X Commissioning Instructions
)
x
x
x
Diagnostics (see
Diagnostics
on
page 12
)
x
x
x
Response level (see
Response Levels
on
page 14
)
x
x
x
Sailboat settings (see
Sailboat setup procedures
on
page 15
):
Auto Tack
Gybe Inhibit
Wind Trim
x
Patterns (see
Power boat and fishing boat setup procedures
on
page 17
)
x
x
Содержание ST70 Instrument
