3.5 General location requirements
Important considerations when choosing a suitable
location for your product.
This product is suitable for mounting above or below
decks.
The product should be mounted where it will be:
• protected from physical damage and excessive
vibration.
• well ventilated and away from heat sources.
• away from any potential ignition source such as an
engine room, near fuel tanks or a gas locker.
When choosing a location for the product,
consider the following points to ensure reliable and
trouble-free operation:
•
Access
— there must be sufficient space to
enable cable connections to the product, avoiding
tight bends in the cable.
•
Diagnostics
— the product must be mounted in
a location where the diagnostics LED is easily
visible.
Note:
Not all products include a diagnostics
LED. Refer to the
Chapter 7
System checks
and troubleshooting
for more information.
•
Electrical interference
— the product should be
mounted far enough away from any equipment
that may cause interference such as motors,
generators and radio transmitters / receivers.
•
Magnetic compass
— refer to the
Compass
safe distance
section in this document for advice
on maintaining a suitable distance between this
product and any compasses on your vessel.
•
Power
— to keep cable runs to a minimum, the
product must be located as close as possible to
the vessel’s dc power supply.
•
Mounting surface
— ensure the product is
adequately supported on a secure surface. Refer
to the weight information provided in the
Technical
specification
for this product and ensure that the
intended mounting surface is suitable for bearing
the product weight. Do NOT mount units or cut
holes in places which may damage the structure
of the vessel.
Product dimensions
3.6 Warnings and cautions
Important:
Before proceeding, ensure that you
have read and understood the warnings and
cautions provided in the
Chapter 1
Important
information
section of this document.
14
