Base station and Raymic handset
software compatibility
The Raymic Handset’s software version must be compatible with
the software installed on the Base station.
Ray90 / Ray91 software compatibility
To be compatible with your Ray90 or Ray91 the handset must be
running software version VH1.26 or greater.
Ray60 / Ray70 software compatibility table
Base Station software
Compatible Handset software
V1.40
VH1.09
V1.39
VH1.09
V1.35
VH1.06
V1.31
VH1.06
V1.24
VH1.01 / VH1.04
V1.22
VH1.01 / VH1.04
V1.13 (
Ray70
introduction)
VH1.01 / VH1.04
V1.06 (
Ray60
introduction)
VH1.01 / VH1.04
V1.04 (
Ray50
only)
N/A
Important:
Please ensure compatible software versions are installed on
both the Base station and Handset. The Handset will not
operate correctly if incompatible software versions are used.
Powering the handset
To power the Handset on and off follow the steps below.
With the Base station powered On:
1. Press and hold the
Power
button, located on the top of the
Handset, for 2 seconds.
The Handset will power on.
2. To power off the Handset, press and hold the
Power
button for
approximately 3 seconds, until the screen turns off.
Handset controls
The Handset’s controls are shown below.
1.
Power
— Press to power the handset on. Press and hold for
3 seconds to power the handset off. Momentary press to
access the shortcut list.
2.
PTT
(Push to Talk) — Press and hold to send a voice message.
Release to return to receive mode.
Note:
The maximum transmit time is limited to 5 minutes
to prevent un-intentional transmissions from occupying the
VHF channel.
3.
Microphone location
4.
Channel Up
and
Channel Down
— Changes to the next or
previous VHF channel, also used to select or adjust setting
options in the menu.
5.
LCD screen
6.
Back
— Go to the previous menu/screen. Press and hold to
return to the Homescreen.
7.
OK / menu button
— Press button to access menu / DSC
functions and to confirm selections.
8.
16 / +
— When powered on press to switch between priority
channels.
9.
HI/LO
— Press to switch between High (25 W) and low (1 W)
transmit power.
10.
DISTRESS
— Lift up the spring loaded cover and press this
button to make a DSC distress call.
11.
Volume Up
and
Volume Down
— Press to adjust volume or
squelch up or down.
12.
VOL/SQ
— Press button to switch between volume and
squelch control.
13.
Built-in speaker
Ray60 / Ray70
Second handset station — Ray60 / Ray70
The Raymic handset accessory can be connected to the second
station connector located on the rear of the radio, this will create a
second fully functional station.
2
Raymic wired handset installation instructions
