5.1 Surface mounting
The unit can be mounted on a surface that is up to
approximately 28 mm (1.10 in) thick using the fixings
supplied with the unit. To mount on a thicker surface
longer studs will be required.
1.
Ensuring correct orientation, affix the supplied
mounting template to the mounting surface at the
desired location.
2. Drill 3 x fixing holes and 1 x cable hole using drill bit
sizes as indicated on the template.
3. Place the waterproof gasket into position on the
underside of the unit.
4. Connect the cable to an available
SeaTalk
ng
spur
connection then connect the other end to the
connector on the underside of the unit and secure
using the locking collar.
5. Screw the threaded studs into the underside of the
unit (these should be hand-tight only).
6. Position the unit so that the mounting studs pass
through the holes in the mounting surface.
7. Secure the unit to the mounting surface using the
thumb nuts. (these should be hand-tight only).
5.2 Pole mounting
The Pole mount kit (A80370) can be used to mount
your product on a pole or rail.
Pole mounting requires a pole with a 1 inch 14 TPI
thread:
1. Screw the Pole mount adaptor to the top of the pole.
2. Feed the cable through either:
• 2a) the center of the Pole mount adaptor and
pole, or
• 2b) the cable exit hole.
3. Connect the cable to an available
SeaTalk
ng
spur
connection then connect the other end of the cable
to the connector on the underside of the unit and
secure using the locking collar.
4. Ensuring correct orientation, Secure the unit to the
Pole mount adaptor using the fixings supplied with
the adaptor.
5. Fix the unit’s orientation by tightening the grub
screws.
The grub screws and their captive nuts are supplied
fitted to the adaptor.
26
