•
[Low voltage]
If enabled, the alarm is triggered if the supply voltage to the
display drops below the value specified in the
[Low voltage threshold ]
field.
•
[Off track]
— If enabled, during active navigation an alarm is triggered
when your vessel steers off track by more than the specified
[Cross track
error]
value.
•
[Position drift]
— If enabled, an Alarm is triggered when your vessel drifts
from its current GNSS (GPS) position by more than the specified
[Drift
range]
.
•
[Water temperature alarm]
— If enabled, an alarm is triggered when the
water temperature reading reaches the temperature specified in
[Lower
temp limit]
or
[Upper temp limit]
.
•
[Fish detection beep]
If, enabled the alarm is triggered when the Fishfinder
app detects a sonar targets that the fish detection algorithm considers to
be a fish. For further details refer to:
•
[Engine alarms]
— If enabled, alarms will be triggered when engine warning
alarms are received from connected, compatible engine management
systems or interfaces.
•
[Satellite fix lost]
If enabled, the alarm is triggered if the position fix of the
GNSS (GPS) receiver currently in use is lost.
•
[Minimum sonar depth]
— When your sonar transducer detects depths of
0.8 m/2.62 ft the alarm is triggered.
Important:
Accurate bottom tracking can be unreliable in depths
shallower than 0.8 m/2.62 ft. When operating at or below this depth be
cautious of misleading sonar returns or false bottom tracking.
AIS dangerous targets
If AIS targets enter a dangerous target state they can trigger an alarm on your
display. AIS targets are considered to be dangerous if they will pass within a
specified safe distance from your vessel within a specified time interval.
The dangerous target alarm can be enabled and disabled from the alarms
menu:
[Homescreen > Settings > Alarms > Dangerous AIS targets ]
.
The dangerous target alarm can be configured from the Dangerous target
page, accessed from the alarms menu:
[Homescreen > Settings > Alarms >
Dangerous AIS targets > Configure]
.
To set up the AIS dangerous target alarm, first adjust the
[Safe distance]
to
the desired value and then select a
[Time to reach safe distance]
. The alarm
will be triggered if a tracked target will reach the specified Safe distance from
your vessel within the time period selected.
You can display a Safe distance ring around your vessel in the Chart app and
Radar app by enabling
[Show safe distance]
.
5.8 Settings menu
The display’s settings can be accessed by selecting the
[Settings]
icon on
the Homescreen.
The following settings and details are available for your display.
47
