Raymarine E-Series, Руководство по установке

Страница: 62 / 112

5.2 Mounting - c Series and e Series
Removing the rear bezel
You must remove the rear bezel before surface
mounting the display.
Note: These steps do not apply to the e165 as it
does not require a rear bezel.
1. Remove the front bezel. Refer to the separate
instructions provided for that procedure.
D12184-3
e7 / e7D
1
3
2
2. Remove the screws that secure the bezel to the
display (only required for e7 and e7D).
3. Carefully remove the bezel from the rear of the
display, pulling the bezel gently along the:
i.
Outer edges - work from the sides upwards
and then along the top edge, ensuring that the
clips are fully released from the display.
ii. Inner edges - ensure that the bezel is
completely removed from the display.
Note: Only the e7 and e7D have fixing screws for
the rear bezel, other multifunction display variants
have clips which hold the rear bezel in place.
Surface mounting
The display can be surface mounted.
Before mounting the unit, ensure that you have:
• Selected a suitable location.
• Identified the cable connections and route that the
cables will take.
• Detached the front bezel.
D12271-2
1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel
is required.
2. Fix the appropriate cutting template supplied
with the product, to the selected location, using
masking or self-adhesive tape.
3. Using a suitable hole saw (the size is indicated
on the template), make a hole in each corner of
the cut-out area.
4. Using a suitable saw, cut along the inside edge
of the cut-out line.
5. Ensure that the unit fits into the removed area
and then file around the rough edge until smooth.
6. Drill 4 holes as indicated on the template to
accept the fixings.
7. Place the gasket onto the display unit and press
firmly onto the flange.
8. Connect the power, data and other cables to the
unit.
9. Slide the unit into place and secure using the
fixings provided.
Note: The supplied gasket provides a seal
between the unit and a suitably flat and stiff
mounting surface or binnacle. The gasket should
be used in all installations. It may also be
necessary to use a marine-grade sealant if the
mounting surface or binnacle is not entirely flat and
stiff or has a rough surface finish.
Attaching the rear bezel
The rear bezel must be fitted if you wish to use a
mounting bracket to mount the unit.
Note: These steps do not apply to the e165 as it
does not require a rear bezel.
1. Remove the front bezel. Refer to the separate
instructions provided for that procedure.
2. Place the bezel over the rear of the display,
ensuring that it is correctly aligned with the
display. Apply firm but even pressure to the bezel
along the:
62 a Series / c Series / e Series installation instructions