Raymarine AXIOM 2 PRO, Руководство по установке

Страница: 42 / 126

3. Using the Trunnion bracket as a template, mark and drill the 5 x pilot
holes on the mounting surface.
4. Secure the trunnion bracket to the mounting surface using your self
tapping screws and an appropriate screwdriver.
5. Insert the trunnion knobs into the sides of the display and tighten 3 to
4 turns.
6. Slide the display into the trunnion bracket so that the trunnion knob
threads are slotted into the recesses in the trunnion bracket.
7. Secure the display by fully tightening the trunnion knobs, ensuring that
the ratchet teeth are correctly engaged.
The knobs should be tightened by hand, sufficiently to prevent the
display from moving whilst your vessel is underway.
8. Route and connect necessary cables.
8.4 Trunnion mounting — Axiom® 2 Pro 16
Tools required (trunnion mount installations)
The following tools are recommended for mounting using a trunnion bracket:
1. Power drill.
2. Screwdriver (appropriate for your fixings).
3.
Drill bit (suitable for the material of the mounting surface and the 5.75 mm
(0.23 in) diameter mounting holes in the trunnion bracket).
4. Torque wrench.
5. Loctite® 243, or equivalent threadlocker.
6. Small flat blade screwdriver (or plastic pry tool).
7. 13 mm (1/2”) socket.
Display trunnion mounting preparation
Axiom® 2 Pro 16 displays are intended to be either surface or flush mounted.
An optional Trunnion bracket kit (part number: A80722) is available if
trunnion mounting is desired. For trunnion mounting, the display needs to be
prepared using the parts supplied in the A80722 kit.
Important:
The display is supplied with rubber trunnion bungs fitted, which must be
removed before the display is trunnion mounted. Do NOT attempt to
trunnion mount the display using the trunnion bungs.
To prepare the display for trunnion mounting, follow the steps below, for
both sides of the display :
42