6
ST30 Depth Operation and Installation Handbook
1.2 Mounting procedure
D627
3
6
5
2
4
1
1 Instrument 2 Fixing studs 3 Thumb nuts 4 Sealing gasket
5 Power supply cable 6 Transducer cable
1.
Make sure the surface to which the instrument (1) is to be mounted is
smooth and flat.
2.
Use the template (supplied) to mark the centres for the fixing studs (2)
and the instrument connector boss.
Note: To allow protective covers to be fitted, adjacent instruments
should be sited not less than 6mm (0.24in) from each other (116mm
centre to centre min.).
3.
Drill two 5mm (0.2in) diameter holes for the fixing studs (2).
4.
Using a 60mm (2 3/8in) diameter cutter, drill a location hole for the
instrument connector boss.
5.
Connect the power supply and transducer cables to the back of the
instrument (1). (See relevant installation sections)
6.
Screw the two fixing studs (2) into the back cover of the instrument
(1).
7.
Install the instrument (1) and secure with the thumb nuts (3) provided.
