Wuhan Raycus Fiber Laser Technologies CO., Ltd.
P30MX Pulsed Fiber Laser User’s Guide V1
@2021 Raycus Corporation
2
a)
Caution: Make sure the corresponding wires of the device are properly grounded.
b)
All the maintenance to the device should only be done by Raycus, because there is no
replacement or accessory provided with the device. Please do not try to damage the labels or
open the cover in order to prevent against electric shock, or the warranty will be invalid.
c)
The output head of the product is connected with an optical cable. Please be careful handling
the output head. Avoid dirt and any other contamination. Please use the specialized lens paper
when cleaning the lens. Please lid the laser with protective cover of the light isolator to be
against dirt only when the laser is not installed in the device or not in working.
d)
If the operating the device fails to follow this instruction, the protective function will be
weakened. Therefore, it should be used under normal conditions.
e)
Do not install the collimating device into the output head when the laser device is in working.
f)
The device has three cooling fans at the rear panel to dissipate heat. In order to guarantee
enough airflow to help giving heat off, there must be a space of at least 10 cm’s width for
airflow in front and rear side of the device. As the cooling fans are working at blow condition,
if laser is mounted in a cabinet with fans, the direction should be same as laser’s fans.
g)
Do not look into the output head of the device directly. Please do wear appropriate laser safety
eyewear during operation of the device.
h)
Make sure the pulse repetition rate(
PRR
) is higher than 1kHz.
i)
The longest time without pulse is only100
s
. If there is no pulse output, please stop marking
at once to avoid the further damage of the device.
j)
Power source sudden interruption will do great harm to the laser device. Please make sure the
power supply works continuously.
