18
4 Using the Product
Raycus CW fiber laser has stopped using the
HyperTerminal, so the HyperTerminal will notworkwhen the
laser is powered on. Please clip the address below to download
the latest PC software and the relevant manual.
4.1 Front Panel
Figure 4 shows the front panel of RFL-C3000S(take RFL-C2000 for example)
：
Figure 5 Front Panel of RFL-C3000S
1. REM/OFF/ON:
Key switch, the power switch of the laser. Insert the key; either turning
the key clockwise to the 'ON' position or counterclockwise to 'REM' position will power
on the laser. Then the laser will enter a control mode depending on your previous setup
on the 'CTRL-INTERFACE'. You can refer to
4.6 Control Mode
for more details.
2. POWER:
PowerIndicator,
GREEN
, indicates that the power is switched on.
3. LASER:
Laser emission indicator,
RED
, illuminates when laser emission is on.
4. ALARM:
Alarm indicator,
YELLOW
, indicates an error condition.
