Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL- RFL-C1500X/C2000X
CAUTION:
Please set the water temperature in strictly accordance with
the requirements above. Too low temperature may lead to condensation on
the laser module and the output cable. This can cause serious damage to
the equipment.
CAUTION:
Make sure that the water temperature reaches the set point
and the cooling system is working well before you start the laser.
〖
summer
：
25
±
1
℃（
RFL-C1500S/C2000S
）；
winter
：
25
±
1
℃
〗
3.4 Installation Procedure
(1) Place the product in an appropriate position, immobilize it if necessary;
(2) Check if the power supply has the correct voltage (See Table 5 for the laser model and
corresponding input voltage ), and the earth line is connected, make sure it is firm and reliable;
(3) Connect the power cable and control cable to the product when power supply is OFF;
(4) Insert the water pipes into the inlet and outlet;
(5) Check the output head and clean it if necessary. This procedure must be performed by
Raycus personnel or person authorized by Raycus. Make sure the environment is clean, or the
output cable may be contaminated.
(6) Prevent the delivery cable from treading, pinching or excessive bending during
installation;
(7) During the installation and disassembly process, please take care to gently put the laser
output head, do not be shocked.
(8) In the installation of laser output cable and output head process, please make sure that
the surrounding environment is clean, otherwise it may pollute the output head (do not use fans
to avoid dust).
(9) The minimum bending radius of the output fiber cable of the laser should not be less
than 20 cm under the non-working conditions, and the minimum bending radius should not be
less than 30 cm when the laser is working.
