Introduction
The installation of the RaycoWylie i4300 system should be performed by an experienced technician. The purpose of this
document is to provide general guidelines by following the below steps. We suggest assembling all components first and
doing all wiring last. For wiring instructions, see provided wiring diagram.
Precaution: Before tearing down the old system, investigate the lock-out wiring. Taking pictures may be a
good idea. When wiring the new system, you will need to know where the lock-out wires were to begin
with.
Component Mounting Steps:
1 Console p/n 33D4300
If this system is replacing a Wylie W1258 or i3500, mount console in existing bolt
holes on the dashboard using supplied bracket and hardware p/n 22KCF0034
If replacing a system other than a Raycowylie, mount console using supplied bracket with or without the flat bar to make
mounting as aesthetic as possible.
2 Canbus Interface Box p/n 33M0109
Install either at foot level or behind the seat in the cab (see below pictures)
OR
