Installation
Important:
This thermostat must be installed according to all national
and local electrical codes. The installation must be performed by quali-
fied personnel.
Locating the floor temperature sensor
The floor temperature sensor is installed under the floor surface. See
the
QuickNet System Installation Manual (H57704),
Section 6, for more
details.
If required, the sensor cable can be extended to about 300 ft (91 m).
Wiring the thermostat
WARNING:
TURN OFF THE POWER TO THE CIRCUIT AT THE MAIN
POWER PANEL TO AVOID ELECTRIC SHOCK.
WARNING:
SHOCK HAZARD. TO PREVENT SHOCK, THE QUICKNET
FLOOR HEATING MAT MUST BE CONNECTED TO GROUND.
WARNING:
SHOCK HAZARD. THIS DEVICE DOES NOT PROTECT
AGAINST ELECTROCUTION WHEN POWERED AT 208 V OR 240 V. A
SEPARATE GROUND FAULT CIRCUIT INTERRUPTER (GFCI CLASS
A) MUST BE USED.
WARNING:
ENSURE THAT THE LINE WIRES ARE CONNECTED
TO THE PROPER TERMINALS. FAILURE TO DO SO COULD CAUSE
SERIOUS BODILY INJURY OR DEATH.
1. Connect power to the thermostat’s line terminals marked “L1 (L)”
and “L2 (N)”. For 120-V installations, be sure the neutral wire is
connected to “L2 (N)”.
2. Connect the floor heating cold lead to the load terminals marked
“Load 15 A Max”.
3. Connect the floor heating cold lead braid (ground) to the supply
ground in the electrical junction box.
4. Connect the floor temperature
sensor to the screw-less
terminals marked “Sensor”.
Push on the terminal spring
with a screwdriver and
insert the wires.
Mounting the thermostat in the electrical box
1. Use a screwdriver to remove the cover.
2. Mount the thermostat in the wall socket and re-attached the cover.
Thermostat Controls and Display Symbols
The following figure shows the thermostat controls:
Reset
GFCI
Test
R
Reset button
Red light indicating
ground-fault
Test button
Pin button for
adjusting clock
Adjustment up
OK - accept
Digital
display
Adjustment down
Reset button for
factory settings
The following figure shows the symbols that appear in the display
window while you are programming:
L1 (L)
L2 (N)
240/(120)VAC
15 A
Max.
QuickStat
®
GFCI Class A
LINE
LOAD
SENSO
R
1/4" (6 mm)
Strip length
Line (black)
Line 2 (red) or Neutral (white)
Cold lead
Cold lead
QuickStat Installation & Operation Manual
2
Supply
ground
Cold lead
ground
Wire nut
Clock function
Manual mode
Time and
temperature
Day number
4-event symbol:
Wake
Night
Out
Home
% switch-on time
Heating on
L1 (L
)
L2 (N
)
240/(120)VAC
16A
Max.
QuickS
tat
®
GF
CI
Class
A
LINE
LOAD
SENSOR
CA
UT
IO
N:
Hig
h V
olt
ag
e -
D
isc
on
ne
ct
po
we
r s
up
ply
b
efo
re
se
rvic
ing
DU
AL
V
OL
TA
GE
5
0/6
0 H
z
38
40
W
/24
0V
AC
(1
6A
)
19
20
W
/2
12
0V
AC
(1
6A
)
