LED Flashlight
1.
Set the Power Switch to ON. Press and hold the Flashlight Button to turn it on.
2.
When the LED flashlight is turned on, press the button again to cycle through SOS- slow flash, warning- quick
flash and OFF mode.
●
The flashlight provides35 hours of continuous use with a full battery.
Troubleshooting (The causes and solutions for the jump cable failure)
Please connect the jump cable with the car battery correctly (Red is positive and Black is negative).
When they are correctly connected, the cable indicator will light up in red. Wait until it turns green to start the car
engine.
LED Flashlight
Flashlight Button
Press and hold
the Flashlight
Button
Press the
Flashlight
Button
Press the
Flashlight
Button
Press the
Flashlight
Button
Flashlight off
Flashlight on
SOS Mode
Warning Mode
Flashlight off
LED Indicator
Causes
Solutions
Red light fast flashes
Short Circuited
DO NOT connect the red and black
cable. Press and hold the Reset
Button for 3 seconds until you see a
solid red light.
Red light slowly blinks
Reverse Connection
Make sure the positive and negative
polarities are correctly connected. Press
and hold the Reset button for 3 seconds
until you see a solid red light.
Green light fast flashes
Battery pack voltage is lower than 10.8V
or remaining battery less than 20%
Check the remaining battery and
recharge the battery pack.
Green light slowly blinks
Repeated use of the jump cable causing
internal temperature to
exceed 90
℃
/ 194°F
Wait for approx. 5 minutes until the
cable cools off and the temperature
drops below 70
℃
/ 158°F.
Red and green light
flashes alternately
The car battery voltage is higher than
that of the battery pack
At first, make sure your gasoline-powered
engine capacity does not exceed 5000 cc
and diesel-powered engine capacity does
not exceed 3000 cc. Then check the
voltage of the battery pack and your car
battery and make sure your car battery
voltage is not higher than that of the
battery pack. And if the battery level is
low, please charge the battery pack first.
When all conditions are met and the
problem still occurs, press and hold the
Reset button for 3 seconds and wait until
the LED indicator turns red.
15/16
