Company Confidential
19
Raveon Technologies Corp.
ATRT 0 CONFIRM
Radio Type 0 for RV-M8-UC Radio modem
ATFC INITIALIZE ALL
Loads factory defaults into channel table
SCB INITIALIZE
Loads the channel banks with default channels
ATIO 5
Digital I/O mode
HWMODE 0
Hardware mode 0
Once the RV-M8-UC is ready to be used on a DART network, make sure all of
these settings are set.
ATMT 5
Hyper/DART modem type
SID xx
Set the system ID
On RV-M8-UC , the periodic reporting must be enabled. This command is set at
the factory to enable GPS periodic reporting.
GXF 1 1
Enable periodic GPS tracking reporting
7. Data Transmission
To transmit data, send one or more bytes of data into the serial port of the
modem. When a full packet of data has been collected into the internal buffer of
the modem, or when there is a pause in the data, the modem will automatically
key its transmitter, and send the data over the air if the modem is within range of
a base station.
Serial Port Baud Rate
While the RV-M8-UC modem is transmitting and receiving data on the DART
network, the user may continue to send more data into the RV-M8-UC
.
Because
the buffers in the RV-M8-UC are full-duplex, the serial port data rate and the
over-the-air data rates are independent. The serial port baud-rates may be set
slow to accommodate legacy equipment, or set at high-speed to minimize
latency.
8. Debug Related Commands
Bench Testing
(Must be in command mode to test. Enter +++ at the keyboard to put unit into config/test mode.)
ATTD x
Various transmit test routines.
0 = Go back to normal mode. Stops the test.
1 = Random data transmit.
3 = Force PLL to fast lock mode
4 = Transmit all 0s
5 = Transmit all 1s
