Raven SmarTrax John Deere 8R 2009 Series, Руководство по установке

Страница: 16 / 28

Chapter 3
12
John Deere 8R-Series - Steering Ready (Model Year 2009-2010) SmarTrax™ Installation Manual
FIGURE 9.
Machine’s Configuration
8.
Determine whether the machine has a wheel angle sensor (WAS) or a flow meter installed.
•
WAS - Trace the WAS cable from the front-left kingpin. Locate and disconnect the 8-pin WAS
connection on the left side of the tractor, then connect the WHEEL ANGLE SENSOR connector on the
valve harness to the machine’s WAS connector. Install the WAS terminator (P/N 063-4001-006) on the
machine’s remaining cable end.
Note:
If the machine contains a WAS, the FLOWMETER connector on the valve harness will not be
used.
•
Flow Meter - Locate and disconnect the machine’s flow meter connection on the left side of the tractor.
Plug the FLOWMETER connector of the valve harness into the flow meter. Install the flowmeter
terminator (P/N 063-4001-007) on the machine’s disconnected flowmeter cable.
Note:
If the machine contains a flow meter, the WHEEL ANGLE SENSOR connector on the valve
harness will not be used.
9.
Sliding the valve harness into the notch, reinstall the cab floor access plate.
Wheel Angle Sensor Connection
Flow Meter