Installation:
19
INSTALLATION
FIGURE 18. IBBC Connector
MASTER INPUT SIGNAL
1. Connect the IBIC connector from the master input adapter cable selected to fit the specific machine to the
existing IBIC connector on the machine. This cable is available in lengths from 1.8 m to 11 m
•
1.8 m [6 ft] (P/N 115-7300-115)
•
3.7 m [12 ft] (P/N 115-7300-116)
•
4.9 m [16 ft] (P/N 115-7300-117)
•
6.1 m [20 ft] (P/N 115-7300-118)
•
7.3 m [24 ft] (P/N 115-7300-119)
•
11 m [36 ft] (P/N 115-7300-120)
NOTE:
If using a Rev. B or newer RCM - Sprayer product control cable (P/N 115-7301-032) , the AUX 6-pin
connector may connect the master boom signal. The ground can be taken from pin J11: 3.
NOTE:
The RCM - Sprayer will turn on when the nozzles are open.
2. If applicable, connect the 3-pin Deutsch connector of the master input adapter cable to the cab master switch
connector.
3. If applicable, the row crop tractor foot switch cable (P/N 115-0172-397) may be connected to the 3-pin Deutsch
master switch connector and then to an existing foot switch connection in the machine.
4. If applicable, the paddle switch adapter cable (P/N 115-0172-422) may be connected to the foot switch cable
(P/N 115-0172-397) and then to an existing paddle switch in the machine.
5. If none of these options apply, a specialized cable will need to be built to connect to the master input signal
from the sprayer itself. This can be done by a master valve at the sprayer or a signal near the sprayer controller.
The switch signal needs to be switched to ground otherwise the RCM - Sprayer will not work.
