CHAPTER 3
10
RCM - Sprayer with Sidekick Pro™ ICD Ratio Rate Quick Installation Reference
ASSEMBLE AND MOUNT THE MIXER
1. Assemble the mixer as shown in Figure 6, “Mixer Assembly,” shown below.
FIGURE 6. Mixer Assembly
NOTE:
Figure 7 on page 11 offers and example of the check valve and the push-in fitting.
2. Mount the mixer near the inlet of the boom.
NOTE:
Refer to Figure 8 on page 11 for an example of mounting the assembly to the implement.
NOTE:
Gaskets, V-bands, the mixer, flow meter, and connector are included in the RCM - Sprayer ratio rate
injection kit (P/N 117-7100-049). The flange couplings to the existing product carrier lines are not
included in the kit. These items need to be ordered separately. The size of the connector at the flow
meter is M200. The size of the connector at the end of the mixer is M220.
3. Place a 3-way hand valve up-stream from the check valve if possible. This valve may be used to drain the
system or for a manual catch test.
Item
No.
Description
Part Number
1
Assembly, M220 Flanged Mixer/Check Valve
063-0173-737
2
Clamp, 2” V-Band
435-3003-048
3
Seal, M220
219-0000-138
4
Fitting, M220-200 Banjo Flanged
333-0002-366
5
Flow Meter, RFM 60P (Deutch DT, HP, 2 Magnet Turbine)
063-0173-291
6
Gasket, 1-1/2” Viton 150G Pakking
219-0000-180
7
Fitting, 8mm x R1/4 Male Stud Elbow BSPT Push-in
333-0014-002
8
Valve, 8mm In-line Non-return Push-in
333-0014-004
9
Clamp, M8 x 60mm Exhaust
311-9000-030
