Manual No. 016-0159-925 Rev. F
31
Initial Startup & Console Programming
Speed Cal
Raven recommends the following speed calibration values for initial system setup.
These values are good starting points and generally yield adequate results, however, the speed cal should be
refined for each specific vehicle and speed sense system. See the
section on page 51 for details on
refining this value.
1.
Use the Edit mode to input a speed cal value.
2.
The Boom Cal screen displays.
Boom Cal
The boom cal value is the width of each boom section in inches [cm]. Up to ten boom cal values may be
programmed into the SCS console.
1.
Use the Edit mode to input the width of the boom section connected to the boom 1 connector or sense wire.
2.
Once a boom cal value has been entered on the Boom 1 Cal screen, the flashing CAL alert will clear and
the initial programming sequence is complete.
It is recommended to program the boom cal values for additional boom sections at this time. Press the UP or
DOWN ARROW keys to access the Boom Cal screens for booms 2-10 and enter the boom widths for these
boom sections.
Note:
To return to the Boom Cal screens after the initial calibration is complete, press the BOOM CAL
key.
Reprogramming Initial Settings
After the initial console programming sequence is complete, if there is a need to change initial console
programming settings (working units, product control type, valve type, or speed sensor type):
1.
Press and hold the SELF TEST key.
2.
The display will flash the current settings. After 12 seconds, the display will stop on US ACRES.
3.
Press CE to change the working units.
4.
Press ENTER to accept the new setting and proceed to the next screen.
5.
Repeat step 3 and step 4 as necessary for the speed sensor type, product control type and control valve
type screens.
Sensor Type
Setting
Sensor Type
English
Metric
Radar/GPS (SP2)
External Raven GPS Receiver
785
199
Internal GPS from
Envizio Pro/Cruizer
812
206
Raven Radar
598
152
Wheel (SP1)
Wheel Magnets
1000
254
Speedometer Drive Speed Sensor
612
155
Содержание SCS 5000 Series
